Do you need a drill to install a curtain rod? If the bracket has screws to keep the rod in position, tighten them to secure it.ĭouble check that the brackets remain secure once the rod and curtains are in place. Lift the rod with curtains onto the brackets. Position the curtain rod in the brackets as a check, then remove it to put the curtains on to it, or to first attach the curtain rings to it, then the curtains to the rings, depending on the type of curtain heading. Use either a screwdriver or drill to fasten the brackets to the wall. If a center bracket is needed, measure and mark the center point between the left and right brackets.ĭrill guide holes for the mounting hardware and be sure to fit wall anchors to create sufficient support. ‘A center bracket is necessary when you have anything more than a single window,’ says Maggie Griffin. Repeat for the bracket on the other side of the window.īear in mind that an additional bracket may be required. Take the first curtain rod bracket, check it is level with your carpenter's level, then mark the position of the screw holes with a pencil on the wall. Use a pencil to mark the position of the curtain rod brackets on the wall. Unless you are hanging curtains without drilling, you’ll also need to plan where the curtain rod brackets should be placed, which is typically 3 to 6 inches to either side of the window. I didn’t use a liner during this test because I wanted to see whether a shower curtain alone could prevent water from leaving the tub and how well it would dry after getting drenched.Alternatively, providing the ceiling height permits the curtain rod to be installed above the window frame, follow the rule of thumb of installing it 4 to 6 inches above the window or, if you have 6 to 12 inches between the ceiling and window frame, fitting it halfway between the ceiling and the top of the window frame.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |